Milwaukee pH Messgerät pH 600

• Accuracy: ±0.1 pH
• Calibration: 1 Point
• Range: 0.0 - 14.0 pH
• Manual: Milwaukee pH600 Manual

Summary

The Milwaukee pH600AQ compact pen tester is specifically designed to help maintain aquariums and aquaculture. Keeping the proper pH improves results for aquarium fish and quality in a range of fish raised in aqulculture.
Use digital accuracy to keep pH in your target range for better results.

Design Features

• Fast, accurate results with digital LCD readout.
• Easy measurement: just place the probe in the sample, gently stir and wait for the reading to stabilize.
• Simple one-point calibration with an easy-to-use trimmer located on the back of the pH tester to protect from accidental splashes.
• Cap to protect the pH sensor and keep it wet when stored upright.
• Low power demand for extended battery life (batteries included).
• Approximate 700 hours of batter use (3 x 1.5 Volt batteries included).
• For Calibration USE MA9007 230 mL bottle of 7.01 pH calibration solution or M10007B box of (25 sachets 20 mL each) calibration solution. These solutions are required to operate the meter properly along with the below links for cleaning and maintaining instructions PH-MAIN.

Maintenance

EC-Elektroden können mit der Zeit Nährstoffablagerungen entwickeln. Um diese Ablagerungen zu verringern, spülen Sie die Sonde nach jedem Gebrauch in frischem Leitungswasser ab.

Use And Care

All pH sensors have a limited life and response time gets longer with age. Properly maintaining your pH pen tester will give you fast, accurate results for longer. So, be sure to order the Milwaukee pH Maintenance Kit code PH-Main at checkout time! This will be needed to help clean and condition the pH electrode before use!
Store the pH probe in storage solution MA9015. Only use tap water short-term if MA9015 is not immediately available and NEVER store in distilled Water (DI) or Reverse Osmosis (RO) water. This will damage the sensitivity of the probe.
Here are our top four tips.
1. Always store upright with the cap full of MA9015 Storage solution for BEST RESULTS.
2. Clean your pH Pen Tester regularly by soaking in cleaning solution MA9016. Cleaning Solution for about 20 minutes.
3. Calibrate after cleaning and/or storage before testing to adjust for changes in the pH sensor.
4. Gently stir the Pen in the sample for a faster result.

Instructions for use